Partnerzy

Streszczenie:
The combination of MCNP6 and the FISPACT codes was used to predict inventories of radioisotopes produced by neutron exposure of a sample in a research reactor. The detailed MCNP6 model of the Budapest Research Reactor and the specific irradiation geometry of the NAA channel was established, while realistic material cards were specified based on concentrations measured by PGAA and NAA, considering the precursor elements of all significant radioisotopes. The energy- and spatial distributions of the neutron field calculated by MCNP6 were transferred to FISPACT, and the resulting activities were validated against those measured using neutron-irradiated small and bulky targets. This approach is general enough to handle different target materials, shapes, and irradiation conditions. A general agreement within 10% has been achieved. Moreover, the method can also be made applicable to predict the activation properties of the near-vessel concrete of existing nuclear installations or assist in the optimal construction of new nuclear power plant units.

Słowa kluczowe:
MCNP6,Monte Carlo simulations,FISPACT,Isotope inventory,Radioisotope production,Neutron activation analysis,Mineral aggregate,Radiation shielding concrete

Streszczenie:
The design of concrete for radiation shielding structures is principally based on the selection of materials of adequate elemental composition and mix proportioning to achieve the long-term durability in nuclear environment. Concrete elements may become radioactive through exposure to neutron radiation from the nuclear reactor. A selection of constituent materials of greatly reduced content of long-lived residual radioisotopes would reduce the volume of low-level waste during plant decommissioning. The objective of this investigation is an assessment of trace elements with a large activation cross section in concrete constituents and simultaneous evaluation of susceptibility of concrete to detrimental alkali-silica reaction. Two isotopes 60Co and 152Eu were chosen as the dominant long-lived residual radioisotopes and evaluated using neutron activation analysis. The influence of selected mineral aggregates on the expansion due to alkali-silica reaction was tested. The content of 60Co and 152Eu activated by neutron radiation in fine and coarse aggregates, as well as in four types of Portland cement, is presented and discussed in respect to the chemical composition and rock origin. Conflicting results were obtained for quartzite coarse aggregate and siliceous river sand that, despite a low content, 60Co and 152Eu exhibited a high susceptibility to alkali-silica reaction in Portland cement concrete. The obtained results facilitate a multicriteria selection of constituents for radiation-shielding concrete.

Słowa kluczowe:
alkali-silica reaction, concrete durability, low-level radioactive waste, neutron activation analysis, radiation shielding concrete, trace elements

Streszczenie:
The assessment of the aggregate suitability for concrete pavements applies mainly to coarse aggregate. However, even fine aggregate can significantly affect the long-term durability of concrete when it is susceptible to alkali-silica reaction (ASR). The sustainable use of available fine aggregates for the production of concrete, while reducing the effects of ASR, requires special preventive measures. The paper proposed different procedures to determine the chemical composition of aggregate and the related ASR risk. The study covers various properties of natural fine aggregates from glacial deposits. The experiments included determination of chemical composition by prompt gamma activation analysis (PGAA), quantitative mineralogical characterisation on thin sections using digital image procedure (DIP) and expansion measurements in mortar bar test (MBT). The strong correlation of sand origin and its susceptibility to ASR was observed. Content of micro- and cryptocrystalline quartz in siliceous sand was found to have a crucial effect on its performance in AMBT.

Słowa kluczowe:
fine aggregate, alkali-silica reaction, mineral composition, prompt gamma activation analysis, digital image procedure, glacial deposit

Streszczenie:
During the decommissioning of nuclear power plants, a significant amount of cement based composites should be disposed as radioactive waste. The use of material with low-activation constituents could effectively reduce radioactivity of concrete. The subject of the paper is the content of trace elements with large activation cross section in concrete constituents due to their ability to be activated in radiation shielding structures. Various Portland cement specimens were subjected to elemental analysis by neutron activation analysis and prompt gamma activation analysis to assess the dominant long-lived residual radioisotopes. Concentrations of the radionuclides, such as Europium-152, Cobalt-60 and Caesium-134 were assessed. Their half-life time is 13.5, 5.27, and 2.07 years, respectively. On the basis of the obtained results, recommendations for cement selection for low-activation concrete are proposed in order to economize decommissioning cost by reducing a radioactive concrete waste.